This is my setup of my SATNOGS station.

It is built in a Z90 enclosure using 3D printed mounts designed in FreeCAD.

These parts provide support for RPi 3 or Pine64 and an RTL-SDR

This is a small modification on CHIP computer that allows to power off the USB port.

I've found my self having access to an ORE 4410D-01 TRACKPOINT II Plus SYSTEM and i tried to plot it's target data on OpenCPN.

This was a chance for acquiring a few skills related to C++, DEB packaging, launchpad.net and Code::Blocks IDE.

On some computers KSP tends to open on the wrong monitor. This is more of a unity problem than a KSP problem and it took me quite a while to sort it out combing through forums.

A ventilator build using a microwave oven fan and a drawer rail.

Following the 100A Fuse repair it was time to investigate what went wrong with the relay that caused the short circuit.

Huge warning/disclaimer on this one, do not repair a fuse as it may result in property damage, fire, electrocution, injury, death, fatigue, loss of appetite, erectile dysfunction, nightmares, PTSD and/or diarrhea.

Having said that, do not do it unless you find your self in some kind of post apocalyptic scenario where you need to restore power to your oil refinery camp in order to defend your self against raiders.

The day has come to replace the steering head bearing on a friends bike. I wanted to try a more elegant approach than heat/hammer/chisel as i needed to save the bearing seal if possible.

Still working on a friends bike, i realized that the water pump assembly was not working properly. After disassembly i saw that the bearing of the impeller shaft was.. let's say it was "in there"... mostly...

How about a cool and fast berry ? This article describes a way to overclock and give a cool breeze to your raspberry Pi...